Fujitsu SPARC ENTERPRISE T1000, Installation Manual, Page: 59 / 84

Chapter 3 Powering On the System 33
a. Set the IP address for the system controller.
b. Set the IP address for the system controller gateway.
c. Set the netmask for the system controller.
This example uses
255.255.255.0
to set the netmask. Your network environment
subnet might require a different netmask. Use a netmask number most appropriate
to your environment.
6. Use the
showsc
command to verify that the parameters were set correctly.
sc> setsc netsc_ipaddr
service-processor-IPaddr
sc> setsc netsc_ipgateway
gateway-IPaddr
sc> setsc netsc_ipnetmask 255.255.255.0
sc> showsc
Advanced Lights Out Manager CMT v1.x
parameter value
--------- -----
if_network true
if_connection ssh
if_emailalerts false
netsc_dhcp true
netsc_ipaddr
xxx
.
xxx
.
xxx
.
xxx
netsc_ipnetmask 255.255.255.0
netsc_ipgateway 0.0.0.0
mgt_mailhost
mgt_mailalert
sc_customerinfo
sc_escapechars #.
sc_powerondelay false
sc_powerstatememory false
sc_clipasswdecho true
sc_cliprompt sc
sc_clitimeout 0
sc_clieventlevel 2
sc_backupuserdata true
diag_trigger power-on-reset error-reset