Fujitsu SPARC Enterprise M4000, Installation Manual

Page: 64 / 76

B-8 SPARC Enterprise M4000/M5000 Servers Installation Guide • December 2010
B.2.5.1
fmadm config
Command
The
fmadm config
command output shows the version numbers of the diagnosis
engines in use by your server, as well as their current state. You can check these
versions against information on the My Oracle Support website to determine if you
are running the latest diagnostic engines.
An example of the
fmadm
output.
B.2.6 Using the
fmstat
Command
The
fmstat
command can report statistics associated with the Oracle Solaris fault
manager. The
fmstat
command shows information about DE performance. In the
example below, the
eft
DE (also seen in the console output) has received an event
which it accepted. A case is “opened” for that event and a diagnosis is performed to
“solve” the cause for the failure.
An example of the
fmstat
output.
XSCF> fmadm config
MODULE VERSION STATUS DESCRIPTION
eft 1.16 active eft diagnosis engine
event-transport 2.0 active Event Transport Module
faultevent-post 1.0 active Gate Reaction Agent for errhandd
fmd-self-diagnosis 1.0 active Fault Manager Self-Diagnosis
iox_agent 1.0 active IO Box Recovery Agent
reagent 1.1 active Reissue Agent
sysevent-transport 1.0 active SysEvent Transport Agent
syslog-msgs 1.0 active Syslog Messaging Agent
XSCF>
XSCF> fmstat
module ev_recv ev_acpt wait svc_t %w %b open solve memsz bufsz
eft 0 0 0.0 0.0 0 0 0 0 3.3M 0
event-transport 0 0 0.0 0.0 0 0 0 0 6.4K 0
faultevent-post 2 0 0.0 8.9 0 0 0 0 0 0
fmd-self-diagnosis 24 24 0.0 352.1 0 0 1 0 24b 0
iox_agent 0 0 0.0 0.0 0 0 0 0 0 0
reagent 0 0 0.0 0.0 0 0 0 0 0 0
sysevent-transport 0 0 0.0 8700.4 0 0 0 0 0 0
syslog-msgs 0 0 0.0 0.0 0 0 0 0 97b 0
XSCF>