Fujitsu SPARC Enterprise M3000, Xscf Reference Manual, Page: 255 / 560

setlocator(8)
System Administration 231
NAME
setlocator - control the blinking of the CHECK LED on the operator panel
SYNOPSIS setlocator value
setlocator
-h
DESCRIPTION
setlocator
(8) command controls the blink state of the CHECK LED on the
operator panel.
The following states can be set:
Privileges You must have
platadm
or
fieldeng
privileges to run this command.
Refer to
setprivileges
(8) for more information.
OPTIONS The following option is supported:
OPERANDS The following operand is supported:
EXTENDED
DESCRIPTION
The
showlocator
(8) command can be used to check the CHECK LED state.
EXAMPLES
EXAMPLE 1
Starts the CHECK LED blinking.
EXAMPLE 2
Stops the CHECK LED blinking.
Start blinking Makes the CHECK LED blink.
Stop blinking Stops the blinking of the CHECK LED.
-h
Displays usage statement. When used with other options or
operands, an error occurs.
value Specifies the CHECK LED state. One of the following can be
specified:
blink
Starts the CHECK LED blinking.
reset
Stops the CHECK LED blinking.
XSCF>
setlocator blink
XSCF>
setlocator reset