Fujitsu SPARC Enterprise M3000, Xscf Reference Manual, Page: 171 / 560

sendbreak(8)
System Administration 147
NAME
sendbreak - send a break signal to the specified domain
SYNOPSIS sendbreak
-d
domain_id
sendbreak [ [
-q
]
-{y|n}
]
-d
domain_id
sendbreak
-h
DESCRIPTION The
sendbreak
(8) command sends a break signal to the specified domain.
When a break signal is sent from the domain console to the Solaris OS of the
domain, control is transferred from the Solaris OS to OpenBoot PROM and the
OpenBoot PROM prompt "
ok
" is displayed.
Note –
sendbreak
(8) command will not work when the secure mode is set to '
on
'
while the mode switch on the operator panel is set to "
Locked
". Refer to the
setdomainmode
(8) for more information.
Privileges You must have one of the following privileges to run this command:
Refer to
setprivileges
(8) for more information.
OPTIONS The following options are supported:
EXIT STATUS The following exit values are returned:
SEE ALSO console
(8)
, showconsolepath
(8)
platadm
Can run this command for all domains.
domainadm
Can run this command only for your managed domains.
-d
domain_id Specifies only one ID of the domain to which to send the break
signal.
domain_id can be
0
–
23
depending on the system
configuration.
-h
Displays usage statement. When used with other options or
operands, an error occurs.
-n
Automatically answers "
n
" (no) to all prompts.
-q
Suppresses all messages to stdout, including prompts.
-y
Automatically answers "
y
" (yes) to all prompts.
0
Successful completion.
>0
An error occurred.