Fujitsu SPARC Enterprise M3000, Xscf Reference Manual, Page: 147 / 560

rebootxscf(8)
System Administration 123
NAME
rebootxscf - reset the XSCF
SYNOPSIS rebootxscf [ [
-q
]
-{y|n}
]
rebootxscf
-h
DESCRIPTION The
rebootxscf
(8) command resets the XSCF.
The settings configured by using the following commands will be applied to XSCF
after you reset XSCF by using the
rebootxscf
(8) command.
■ applynetwork
(8)
■
setaltitude
(8)
■
setdualpowerfeed
(8)
■ sethttps
(8)
■ setntp
(8)
■
setssh
(8)
■ settelnet
(8)
In the M8000/M9000 servers, both of the active XSCF and the standby XSCF will be
reset.
Privileges You must have
platadm
or
fieldeng
privilege to run this command.
Refer to
setprivileges
(8) for more information.
OPTIONS The following options are supported:
EXTENDED
DESCRIPTION
■
When the command is executed, a prompt to confirm execution of the command
is displayed. Enter "
y
" to execute the command or "
n
" to cancel the command.
■
The
rebootxscf
(8) command terminates all connection to XSCF, such as telnet
or ssh.
■
When you cancel the XSCF reset using the
setdate
(8) which commands reset
XSCF automatically, even if you perform this command, the information that is
set is not applied in XSCF.
-h
Displays usage statement. When used with other options or
operands, an error occurs.
-n
Automatically answers "
n
" (no) to all prompts.
-q
Suppresses all messages to stdout, including prompts.
-y
Automatically answers "
y
" (yes) to all prompts.