Fujitsu ScanSnap iScanner fi-6010N, Operator'S Manual

Page: 187 / 665

4.7 Using the Network Settings Menus
fi-6010N Network Scanner Operator's Guide 149
4
4.7.16 Setting the Destination for Alert Notifications
An e-mail address can be specified to which an alert notification will be sent whenever a scanner
alert situation occurs.
If an SMTP server has not been setup, alert notifications cannot be sent. For more details about
how to set an SMTP server, refer to
"4.7.11 Setting the e-Mail Server (SMTP Server)" (page 116) .
When the destination for alert notification is set, alert notification messages will be sent to the reg-
istered e-mail address in the following title.
Network Scanner (
XXXX
) Error
For more details, refer to "E.1.3 Alert Monitor System Log Messages" (page 524) .
1. Select the [Network Settings] tab on the top menu.
2. Select the [Alert Notification] tab on the left side menu.
The "Alert Notification" screen appears.
3. Enter an e-mail address to which the alert notification will be sent.
For details about e-mail address settings values, refer to "B.1 e-Mail Address Setting Val-
ues" (page 490) .
4. To confirm that the entered e-mail address is valid, press the [Test] button.
Check that the test mail successfully arrives at the expected e-mail address.
5. Press the [OK] button.
The destination for alert notifications is set.