Fujitsu ScanPartner SP25, Operator'S Manual, Page: 65 / 164

Chapter 4 Various Ways to Scan
Appendix
Glossary
Introduction
Index
Contents
TOP
65
How to Load
Documents
Daily Care
Troubleshooting
Operational
Settings
Replacing the
Consumables
Scanner
Overview
Various Ways to
Scan
How to Use the
Operator Panel
Scanning a Large Document on the Flatbed
(ScanPartner SP30F)
1
Open the document cover.
For details, refer to "1.5 Opening/Closing the Document Cover
(ScanPartner SP30F)" (page 26) .
2
Remove the document cover by pulling it out in the
direction of the arrow.
3
Load the document on the document bed.
Place the document face-down to align its top left-hand corner with
the reference point.
4
In the scanner driver, configure the scan settings for using
the flatbed.
For details, refer to the scanner driver's Help.
5
Scan the document with the image scanning application.
For details, refer to the manual of the image scanning application.
6
Attach the document cover.
Do not look directly into the light source.
ATTENTION
Do not move the document during scanning.
Reference point