Fujitsu ScanPartner SP25, Operator'S Manual

Page: 136 / 164

Chapter 8 Operational Settings
Appendix
Glossary
Introduction
Index
Contents
TOP
136
How to Load
Documents
Scanner
Overview
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Troubleshooting
Replacing the
Consumables
Operational
Settings
Shortening the Scanning Intervals [Pre-Pick]
"Pre-pick" refers to feeding the document to the starting
position for scanning before the next scan.
Enabling [Pre-Pick] shortens the interval between scanning
each document.
1
Start up the Software Operation Panel.
For details, refer to "8.1 Starting Up the Software Operation Panel"
(page 116) .
2
From the listing on the left, select [Device Setting 2]
J
[Pre-Pick].
3
Select [Yes] or [No].
HINT
z If you cancel in the middle of scanning while pre-pick is
enabled, you will have to remove the pre-picked document,
then load the document again.
z This setting can also be configured in the scanner driver. Note
that priority is given to the scanner driver setting.