Fujitsu Primergy TX300 S4, User Manual, Page: 215 / 276

215
PRIMERGY TX300 S4 User’s Guide
7.2.17 Console Redirection Submenu
This submenu appears when you select [Console Redirection] from the [Server] menu.
It is for detailed settings of console redirection that uses a serial port.
table: Console Redirection submenu
Item Setting Description
Console Redirection • Disabled (Initial value)
• Enabled Sets whether to enable console redirection. When
"Enabled" is set, the following items appear. Set each
item.
Port
• Serial 1 (Initial value)
• Serial 2
Sets the serial port used for console redirection.
Baud Rate • 1200
• 2400
• 4800
• 9600 (Initial value)
• 19.2K
• 38.4K
• 57.6K
• 115.2K
When console redirection is used, use this item to set
the baud rate to be used for console redirection.
Protocol
• VT100
• VT100, 8bit
• PC-ANSI, 7bit
• PC-ANSI
• VT100+ (Initial value)
When console redirection is used, use this item to set
the console type for console redirection.
Flow Control • None
• XON/XOFF
• CTS/RTS (Initial value) Sets the flow control.
Mode
• Standard
• Enhanced (Initial value) Sets the scope of use for console redirection.
PhoenixBIOS Setup Utility
Item Specific Help Console Redirection
Select Item
Select Menu
Change Values
Select > Sub-Menu -/+
Enter
F1
Esc
Exit
F9 Setup Defaults
Advanced Security Server Exit Main
Console Redirection: [Disabled]