Fujitsu Primergy TX300 S4, User Manual, Page: 200 / 276

200
Chapter 7 Configuring Hardware and Utilities
7.2.6 Peripheral Configuration Submenu
This submenu appears when you select [Peripheral Configuration] from the [Advanced] menu.
It is for setting the serial port, parallel port, etc.
Use a scroll bar to display the hidden areas of the screen.
table: Peripheral Configuration submenu
Item Setting Description
Serial 1 • Disabled
• Enabled
• Auto (Initial value)
• OS Controlled Sets whether to enable or disable the serial port. Set
this item to "Disabled" when you use it as a server
management port.
Note:
`
When [Serial Multiplexer] is changed to
"iRMC", set this item to "Disabled".
Serial 1 Address 3F8h (Unchangeable) Appears when [Serial 1] is "Enabled".
Serial Multiplexer • System (Initial value)
• iRMC Switches the function of serial port 1 as below:
• System
Uses this port as a serial port (setting where UPS
is used).
• iRMC
Uses this port as a server management port. Set
[Serial 1] to "Disabled".
Serial 2 • Disabled
• Enabled
• Auto (Initial value)
• OS Controlled Sets whether to enable or disable the serial port.
Serial 2 Address 2F8h, IRQ 3 (Unchangeable) Appears when [Serial 2] is "Enabled".
Parallel • Disabled (Initial value)
• Enabled
• Auto Sets whether to enable or disable the parallel port.
Parallel Mode • Bidirection (Unchangeable) Sets the data transfer mode of the parallel port.
Appears when [Parallel] is "Enable" or "Auto".
Parallel Address
• 378h, IRQ7 (Unchangeable)
Appears when [Parallel] is "Enabled".
PhoenixBIOS Setup Utility
Item Specific Help
Select Item
Select Menu Change Values
Select > Sub-Menu -/+
Enter
F1
Esc
Exit
F9
Setup Defaults
Advanced Security Server Exit Main
Peripheral Configuration
Serial 1:
Serial Multiplexer:
Serial 2:
Parallel:
USB Host Controller:
USB 2.0 Host Controller:
USB BIOS Supported Devices:
USB Boot Delay:
USB BIOS Hot-Plug:
USB Front
USB Rear
ATA Controller Config
Configure serial port
using options [Auto]
[System]
[Auto]
[Disabled]
[Enabled]
[Enabled]
[Auto]
[0 s]
[Enabled]
[Enabled]
[Enabled]
[Disable]
No configuration
[Enabled]
User configuration
[Auto]
BIOS or OS chooses
configuration
>