Fujitsu PRIMERGY TX200 S2, User Manual

Page: 128 / 317

128
Chapter 4 Manual OS Installation
• When a recognized network adapter is not present
Perform "
■
Installing the LAN Driver" ( pg.129) on [Ethernet controller] under [Other devices].
When the LAN driver is installed to [Other devices] before updating the driver for the network
adapter recognized immediately after the OS installation
When driver installation starts, the following window appears.
Clicking [Finish] displays the [Help and Support Center] window. Click [X] to close the window.
After installation, the "!" mark is displayed at the LAN device name in Device Manager. Device names
are displayed properly when all LAN drivers are installed and the system is restarted.
■
Updating LAN Drivers
Perform the following procedures on all LAN device names under [Network adapters] in [Device
Manager].
1
Double-click a LAN device name under [Network adapters].
Names of the LAN devices are displayed as follows.
2
Insert the driver disk created from the ServerStart CD-ROM into the server.
3
Click [Update Driver] in the [Driver] tab window.
The "Welcome to the Hardware Update Wizard" window appears.
4
Select [Install the software automatically (Recommended)] and click [Next].
The driver will be installed.
5
Click [Finish].
table: LAN device name
LAN cards LAN device name
PG-1852 Intel(R) PRO/1000 MT Desktop Adapter
PG-1862 Intel(R) PRO/1000 MT Dual Port Server Adapter