Fujitsu PRIMERGY TX1310 M3, Upgrade And Maintenance Manual

Page: 72 / 234

72 Upgrade and Maintenance Manual
TX1310 M3
Basic software procedures
5.2.10 Looking up changed MAC / WWN addresses
When replacing a network controller or SFP+ transceiver module, the MAC
(Media Access Control) and WWN (World Wide Name) addresses will change.
I
In addition to the procedures described below, MAC / WWN addresses
can also be found on the type label attached to a network controller or
system board.
5.2.10.1 Looking up MAC addresses
Ê
Enter the BIOS.
Ê
Depending on the number of network controllers in your system, you will find
one or several
Port Configuration menu items.
Use the arrow key
ç
to scroll to the right and browse all available tabs.
Each Port Configuration tab will display detailed information on the related
network controller, including its MAC address.
Ê
Note down the new 12-digit MAC address.
Ê
Press
[Esc]
to exit the BIOS.
Ê
Inform the customer about the changed MAC address.
5.2.11 Using the Chassis ID Prom Tool
The Chassis ID EPROM located on a dedicated Chassis ID board or on the front
panel board of your server contains system information like server name and
model, housing type, serial number and manufacturing data.
In order to integrate your system into the ServerView management environment
and to enable server installation using the ServerView Installation Manager,
system data needs to be complete and correct.
After replacing the Chassis ID EPROM, system information has to be entered
using the Chassis ID Prom tool. The tool and further instructions are available
to maintenance personnel from the Fujitsu web pages:
https://partners.ts.fujitsu.com/com/service/ps/Servers/PRIMERGY/
Ê
Select your PRIMERGY system from the main area of the page.
Ê
From the categories selection, choose Software & Tools Documentation .