Fujitsu Primergy TX120, User Manual

Page: 140 / 263

140
Chapter 5 Operations after OS Installation
5.5 Notes before Operating the
Server
This section explains the settings required before starting to operate the server.
For details on the settings, refer to the following URL.
http://www.microsoft.com/technet/prodtechnol/exchange/2003/Library/default.mspx
• If a LAN card was added, install a driver according to "4.3 Installing the LAN Driver" (
J
pg.117).
• For the settings for the installed applications supplied with the product, refer to the manuals of each
application.
• For consideration for the security of ServerView, refer to "ServerView User's Guide".
5.5.1 Auto-run Function from CD-ROM Drives
Perform the following procedures to change the settings of the auto-run function from the CD-ROM
drives after server installation:
1
Make the registry editable, and change the value of AutoRun of the following
registry key:
HKEY_LOCAL_MACHINE\System\CurrentControlSet\Services\CDRom
Set the value of Autorun to "1" to enable auto-run, and set the value to "0" to disable auto-run.
2
Restart the system.
The setting is enabled after the system is restarted.
5.5.2 Drive Letter Assignment in Expert Mode
In expert mode, you cannot specify a drive letter to a particular partition arbitrarily. Drive letters
specified with Disk Manager in expert mode will be sequentially assigned from the first partition with
"C, D, E..." when installation is completed, and an unused drive letter will be assigned to the CD-ROM
drive.
To change the drive letter, perform the following procedures after installation.
` You cannot change the drive letters for the system and boot drive.
1
Click [Start]
→
[Administrative Tools]
→
[Computer Management].
2
Click [Disk Management].