Fujitsu PRIMERGY RX600 S4, User Manual

Page: 34 / 230

34
Chapter 1 Overview
1.4.3 Turning Off the Server
1
Make sure the CD/DVD drive is empty.
2
Shut down the OS.
After the OS is shut down, the server is turned off.
`
If the power is set not to be turned off after the OS is shut down, make sure the hard disk
access LED is off, and press the system power button of the server. And then, the sys-
tem power LED is lit amber.
3
Turn off the display and peripheral devices.
` The time to turn off the server can be set with the ASR setting (on the [Power On/Off] tab) using
ServerView. For details, refer to "3.4 Serious Error Handling (ASR)" in "ServerView User's Guide".
„
Cautions when turning the power off (Windows Server 2003)
For the power switch operation mode of this server, you can specify the following modes depending on
the OS settings (normally, "Shutdown" is specified).
"Do Nothing", "Prompt Input", "Standby", "Hibernation", or "Shutdown"
On this server, functions corresponding to "Standby" and "Hibernation" are supported as BIOS and
hardware functions. However, some drivers and software installed in the server do not support these
functions. For this reason, functions corresponding to "Standby" and "Hibernation" are unavailable on
this server. When the operating mode is set to "Standby" or "Hibernation", the system may operate
improperly or hard disk data may be corrupted.
For details about operating mode settings, refer to the manual supplied with the OS.
• In the event of smoke or sparks, immediately disconnect the electric
cord. Failure to do so may lead to a fire or electric shock.
• Follow the procedures below to turn off the server. Data can be lost if
these procedures are not followed correctly.
• Be sure to wait for 10 seconds at least after shutdown before turning the
server on.