Fujitsu PRIMERGY RX600 S4, User Manual

Page: 198 / 230

198
Chapter 8 Operation and Maintenance
z
User password (User password)
The password required to use the server. Unless the set password is entered, part of the BIOS setup
cannot be accessed and the OS cannot be booted.
z
Administrator password (Supervisor password)
This is the password that only allows the administrator to set up this server. Unless the set password is
entered, the BIOS setup cannot be accessed and the OS cannot be booted.
„
Setting a password
The password is set in BIOS Setup Utility. For details on BIOS Setup Utility, refer to "7.2.11 Security
Menu" (
J
pg.163).
1
Start up BIOS Setup Utility.
J
"7.2.1 Starting and Exiting BIOS Setup Utility" (pg.151)
2
Select the [Security] menu and select the type of password to set.
• For the administrator password, select [Set Supervisor Password] and press the [Enter] key.
• For the user password, select [Set User Password] and press the [Enter] key.
3
When the password window is displayed, enter the password to set.
4
Enter the password again to confirm it.
5
Press the [Enter] key.
The password is set.
z
Changing/deleting a password
If a password is already set, perform the password setting operations above to display the password
change window.
• To change the password, perform the following settings and press the [Enter] key.
• To delete the password, enter the current password, and then press the [Enter] key without entering
anything in the second and third fields. The status of "User (Supervisor) Password" changes to "Not
installed".
Set User(Supervisor) Password:
Enter New Password [ ]
Confirm New Password [ ]
Enter the password
Enter the password again for confirmation
Set User(Supervisor) Password:
Enter Current Password [ ]
Confirm New Password [ ]
Enter New Password [ ]
Enter the current password
Enter the new password
Enter the new password again for confirmation