Fujitsu PRIMERGY RX600 S3, User Manual

Page: 54 / 305

54
Chapter 2 Checking before OS Installation
2.3.5 Expansion Cards Supported by ServerStart
ServerStart supports automatic driver installation for the following expansion cards.
2.3.6 Cautions for Manual Installation
„
Notes on Using an onboard SCSI array controller
The onboard SCSI array controller must be configured before the OS is installed. To check the onboard
SCSI array controller settings, start up WebBIOS. For more details, refer to "PRIMERGY RX600 S3
Onboard SCSI RAID User’s Guide".
„
Free Space Required for Installation
The partition where the OS is installed must have enough free space for obtaining memory dump. For
more details, refer to"5.1 Memory Dump/Paging File Setting" (
J
pg.138).
„
Cautions on Restarting
In the course of installation, a message appears to indicate that the setup program restarts. Wait until it
restarts automatically.
For background operations, refer to "PRIMERGY RX600 S3 Onboard SCSI RAID User’s Guide".
table: Automatic Expansion Card Driver Installation
Name Model Bus
Onboard SCSI array controller - PCI
Onboard LAN - PCI
Onboard VGA - PCI
LAN Card PG-2861 PCI-Express
PG-1862 PCI
PG-1882 PCI
PG-1892 PCI
RAID Ctrl 2-Channel 128MB w/ BBU
PG-142E3 PCI
SCSI Ctrl U160 PG-1281 PCI
Fibre Channel Controller PG-FC202 PCI-Express