Fujitsu Primergy RX600 S2, User Manual

Page: 167 / 299

167
PRIMERGY RX600 S2 User’s Guide
5
Operatio
ns
after O
S
In
st
al
lation
5.7.3 Cautions for PG-1852/1862/188x/189xLAN Driver V9.2
■
Event Log
Once a Team is setup, multiple identical logs from the same source that starts with the following log may
be stored in the system log file of the event viewer at system start-up.
Since such event logs will be stored nonetheless even if the Teaming function is operated normally,
ignore them.
5.7.4 Teaming Function
■
Notes
When using the Teaming function, note the following points.
• You require Service Pack 2 or later for Windows 2000 Server.
• For AFT/ALB/Static link type, you can incorporate up to four LAN ports into one team and two ports
for a SFT type team.
• Once a Team is created, virtual adapters (Intel
®
Advanced Network Service Virtual Adapter) will be
created in the [Device Manager] and/or [Network and Dial-up Connections] of the system. Do not
disable or delete this virtual adapter from the [Device Manager] or [Network and Dial-up
Connections]. When deleting a virtual adapter, make sure to use "Intel
®
PROSet".
• When the Teaming function is being used, you can only use the following protocols:
• For AFT/SFT/Static link type: IP, NetBEUI, IPX (NCP), IPX (NetBIOS)
• For ALB type: IP, IPX (NCP)
• When the Teaming function is being used, you cannot use the hardware assist function of IPSEC. Do
not use this function even if the function is installed in all cards in the team.
• When the Teaming function is being used, you cannot use Windows Load Balancing Service
(WLBS) and Network Load Balancing (NLB).
• If Static link type is selected, you can only use the switch for link aggregation.
• When adding/deleting a Static link type member, perform such operation under a linked down state.
Only a link down error between a LAN card (onboard LAN) and the switch it connects with, and the
equivalent errors lead to switching of the route. Therefore, if only the switch or LAN card (onboard
LAN) is partially damaged and the route being used is sound at the link level, the route will not be
switched in the team, but the communication with the Team may become an error.
Source iANSMiniport
ID 11
Type Warning
Description The following adapter link is not connected: (adapter name)
* (adapter name) varies depending on the OS or hardware configuration.