155
PRIMERGY RX600 S2 User’s Guide
5
Operatio
ns
after O
S
In
st
al
lation
5.5.5 Turning the Power On via a LAN
You can turn the power on the server from a client (via a LAN) by utilizing the Wakeup on LAN (WOL)
function.
Be sure to install ServerView to control the power supply via a LAN.
When the power cable is disconnected from the server or the server is powered off due to power
interruption, restart the server. Unless the server is restarted, the WOL function will be disabled.
■
BIOS Setup Utility Setting
When power management is performed via a LAN, configure the settings as follows using the BIOS
Setup Utility. This is set to "Enabled" by default.
1
Start the BIOS Setup Utility.
"8.3.1 Starting and Exiting the BIOS Setup Utility" (pg.237)
2
Set [WOL Resume from S5] of the [Server] menu to [Enabled].
3
Press the [F10] key.
The confirmation message whether to save the changes is displayed.
4
Select [Yes] and press the [Enter] key.
To start up the server via a LAN, refer to "
Performing Remote Installation" (
5.5.6 Other Notes on Operation
■
Unnecessary Files
After OS installation is completed, folders named Runonce and Runonce 2 may be left in the drive
where the OS is installed. Delete these folders since you do not need them for the system operation.
■
Notes on 24-hour Operation
●
Automated System Operation
To provide an extra margin of safety against unintentional damage, introduce disaster-prevention
measures in the office and keep disaster prevention personnel (such as a security guard or janitor) in the
building.
Summary of Contents for Primergy RX600 S2
