Fujitsu Primergy RX300 S4, User Manual

Page: 98 / 267

98
Chapter 4 Operations after OS Installation
4.5.5 Turning the Power On via a LAN
You can turn the power on the server from a client (via a LAN) by utilizing the Wakeup on LAN (WOL)
function.
Be sure to install ServerView to control the power supply via a LAN.
When the power cable is disconnected from the server or the server is powered off due to power
interruption, restart the server. Unless otherwise, the WOL function will be disabled.
Only the onboard LAN is available to correspond to the WOL function for this server. To control power
supply via a LAN, connect the onboard LAN and set the onboard LAN adapter bind to "1" for sure.
BIOS Setup Utility setting
When perform power management via a LAN, set [Enabled] in the [LAN] item of the "7.2.9 Power On/
Off Submenu" ( p.196) in the BIOS Setup Utility. The [Enabled] in the [LAN] has been set as the initial
setting.
4.5.6 Changing the system drive size (only for Windows
Server 2008)
For Windows Server 2008, the partition size can be extended or reduced after installation has completed.
Extending the partition size of a system drive
To extend the partition size of a system drive, perform the following procedure.
1
Log on to the server with administrator privileges.
2
Click [Start] – [All Programs] – [Administrative Tools] – [Server Manager].
Server Manager starts.
3
Double-click [Storage] – [Disk Management].
The [Disk Management] window appears.
4
Right-click the volume to be extended in [Disk Management], and click [Extend
Volume].
The [Welcome to the Extend Volume Wizard] window appears.