Fujitsu Primergy RX300 S4, User Manual

Page: 191 / 267

191
PRIMERGY RX300 S4 User's Guide
7.2.6 Peripheral Configuration Submenu
This submenu appears when selecting [Peripheral Configuration] from the [Advanced] menu.
Sets the serial port, parallel port, etc.
The items not listed in the figure below can be displayed using the scroll bar.
table: Items on the Peripheral Configuration Submenu
Item Setting Description
Serial 1 • Disabled
• Enabled
• Auto (Initial value)
• OS Controlled Sets whether to enable or disable the serial port. Set
this to [Disabled] when used as a server
management port.
Note:
When [Serial Multiplexer] is changed to
[iRMC], set this item to "Disabled".
Serial 1 Address 3F8h, IRQ 4
(Unchangeable) Appears when [Enabled] is selected for [Serial 1].
Serial Multiplexer • System (Initial value)
• iRMC Switches the function of serial port 1.
• System
Uses this port as a serial port. (Setting at the time
of UPS connection)
• iRMC
Uses this port as a server management port. In
this case, set [Serial 1] to [Disabled].
Serial 2 • Disabled (Initial value)
• Enabled
• Auto
• OS Controlled Sets whether to enable or to disable the serial port.
Serial 2 Address 2F8h, IRQ 3
(Unchangeable) Appears when [Enabled] is selected for [Serial 2].
Parallel • Disabled (Initial value)
• Enabled
• Auto Sets whether to enable or to disable the parallel
port.
PhoenixBIOS Setup Utility
Item Specific Help
Select Item
Select Menu
Change Values
Select > Sub-Menu -/+
Enter
Advanced
Peripheral Configuration
Serial 1:
Serial Multiplexer:
Serial 2:
Parallel:
Parallel Mode:
USB Host Controller:
USB 2.0 Host Controller:
USB BIOS Supported Devices:
USB Boot Delay:
USB BIOS Hot-Plug:
USB Front:
USB Rear:
ATA Controller Config
[Auto]
[System]
[Disabled]
[Disabled]
[Bidirection]
[Enabled]
[Enabled]
[Auto]
[0 s]
[Enabled]
[Enabled]
[Enabled]
>