Fujitsu PRIMERGY RX2560 M2, Upgrade And Maintenance Manual

Page: 489 / 568

TX2560 M2 / RX2560 M2 Upgrade and Maintenance Manual
489
System board and components
Ê
Lower the system board carefully into the chassis.
Ê
Adjust the system board (orange circles in figure 362 on page 487 show the
centering bolts).
Ê
Fasten the system board with the 10 screws (see figure 362 on page 487 ).
Ê
Insert the crossbar and fasten it with the five screws (see figure 361 on
page 486 ).
Ê
Remove the CPU from the defective system board as described in section
"Removing the CPU" on page 382 .
Ê
Remove the protective plastic cover from the CPU socket of the new system
board and fit it onto the socket of the defective system board which will be
sent back to spares.
I
Returned system boards without this cover probably have to be
scrapped.
Ê
Install the CPU on the new system board as described in section "Installing
the CPU" on page 383 .
Ê
Reconnect all cables to the system board:
– Front panel cable
– Front USB cable
– Power cable(s) for HDD backplane(s)
– SATA cable(s) for HDD backplane(s)
– SATA cable for ODD (if applicable)
I
Loop back the SATA ODD cable and route it along the crossbar as
shown in
figure 294 on page 400 .
– Power cable for ODD (if applicable)
– Front VGA cable (if applicable)
– OOB cable (if applicable)
– I
2
C bus cable (if applicable)
For the cable plan see section "Cabling plans" on page 512 .