Fujitsu PRIMERGY RX2520 M4, Upgrade And Maintenance Manual, Page: 48 / 456

48 Upgrade and Maintenance Manual
RX2520 M4
Basic hardware procedures
Ê
Press the Indicate CSS button to highlight defective components (see
section
"Onboard indicators and controls" on page 393 ).
Component LEDs
Ê
Check the component LEDs on the system board and the server rear (see
section
"Connectors and indicators" on page 391 ).
I
In addition to local diagnostic indicators, CSS or Global Error LEDs
indicate, if the defective component is a customer replaceable unit or if a
service technician needs to be dispatched to replace the part (see
section
"Determining the error class" on page 46 ).
If the system has been powered off to replace a non hot-plug unit, a
system of PRIMERGY diagnostics indicators guides you to the faulty
component.
4.2 Shutting down the server
V
CAUTION!
For more safety information, see chapter "Important information" on
page 33 .
I
This step is only required when upgrading or replacing non-hot plug
components.
Ê
Inform the system administrator that the server will be shut down and put
offline.
Ê
Terminate all applications.
Ê
Perform the required procedures described in the preliminary steps of each
upgrade or maintenance task.
Ê
"Verifying and configuring the backup software solution" on page 70 .
Ê
"Removing backup and optical disk media" on page 69 .
Ê
Shut down the server.
I
If the system is running an ACPI-compliant operating system,
pressing the On / Off button will perform a graceful shutdown.
Ê
Switch on the ID indicator on the front and rear I/O panels of the server, see
section
"Locating the defective server" on page 45 .