Fujitsu Primergy RX200 S4, User Manual

Page: 232 / 269

232
Chapter 8 Operation and Maintenance
8.6 Restoring the System
If the system is damaged, use the backup data created after installation to restore the
system.
Create a recovery disk when you have installed an OS or changed the system configuration. Refer to
"4.2 Creating Backup Data for System Recovery" ( p.79).
When a restoration procedure is described in the backup device manual or Readme.txt included in the
device driver, refer to the procedure instead of this section.
When restoring the system, check that the USB floppy disk drive is connected before turning on the
server's power.
8.6.1 For Windows Server 2008
The whole server can be restored using the Windows Server Backup function.
Items required
• Windows Server 2008 DVD-ROM (Installation disc)
• Backup data created using the Windows Server Backup function (connectable shared folder, DVD,
etc.)
1
Insert the Windows Server 2008 DVD-ROM (installation disc) immediately after
turning on the server.
Check that there is not already a floppy disk inserted in the floppy disk drive at this time.
2
When active area is specified on the hard disk, the following message is
displayed on the bottom of the window. Press any key while the message is
displayed.
The Windows Server 2008 setup window appears.
Press any key to boot ...