Fujitsu PRIMERGY RX1330 M3, Upgrade And Maintenance Manual

Page: 83 / 342

RX1330 M3
Upgrade and Maintenance Manual 83
Basic software procedures
or enter its serial or ident number into the search field.
Ê
Select your operating system and version.
Ê
Select the desired component type (e.g. SAS RAID).
Ê
Select your controller from the device list to expand a compilation of
available drivers and firmware.
Ê
Select the desired file and click
Download
for further instructions.
5.2.4 Enabling Option ROM scan
In order to configure an expansion card that has been installed or replaced, the
card’s Option ROM has to be enabled in the system board BIOS. The card’s
firmware is called by the system BIOS upon reboot and can be entered and
configured.
Option ROM can be enabled permanently (e.g. in case of a boot controller that
may require frequent setup) or temporarily for one-time configuration. When
permanently enabling a controllers’s Option ROM, keep in mind that only two
Option ROMs can be activated in the system board BIOS at a time.
Ê
Enter the BIOS.
Ê
From the Advanced menu select Option ROM Configuration .
Ê
Identify the desired PCI slot and set its Launch Slot # OpROM setting to
Enabled.
Ê
Save your changes and exit the BIOS.
I
Up to two Option ROMs can be activated in the system board BIOS
at a time.
For detailed information on how to access the BIOS and modify
settings, refer to corresponding BIOS Setup Utility reference manual.
When the enabled expansion card is initialized during the POST phase of the
boot sequence, a key combination is displayed temporarily to enter the
expansion card’s firmware.
Ê
Press the displayed key combination.
Ê
Modify the expansion card firmware options as desired.
Ê
Save your changes and exit the firmware.