159
PRIMERGY RX100 S3 User’s Guide
5
Operatio
ns
after O
S
In
st
al
lation
■
For Windows Server 2003, Windows 2000 Server
If the OS was installed using ServerStart, "BACS" is already installed with the driver. If the OS was
installed manually, BACS will not be installed.
1
Execute the following file contained in the ServerStart Disc 1 CD-ROM.
[CD-ROM drive]: \PROGRAMS\GENERAL\Broadcom\MgmtApps\setup.exe
The installer starts up.
2
Proceed the installation by following the window instructions.
When the window below appears during the installation procedure, check [BASP] and click
[Next].
5.6.2 Load Balance
Once a Windows Server 2003 or Windows 2000 Server Team is created, virtual adapters (BASP Virtual
Adapter) will be created in the [Device Manager] and/or [Network and Dial-up Connections] of the
system. Do not disable or delete a virtual adapter from the [Device Manager] or [Network and Dial-up
Connections]. When deleting a virtual adapter, make sure to use BACS.
■
Load Balance Setup Procedure
1
Start up BACS. The procedure differs depending on the OS being used.
For Windows Server 2003
1. Click [Start]
→
[Control Panel]
→
[Broadcom Control Suite 2].
For Windows 2000 Server
1. Click [Start]
→
[Settings]
→
[Control Panel].
The [Control Panel] window appears.
2. Start up "Broadcom Control Suite 2".
