Fujitsu PRIMERGY PG-R1CK6, User Manual, Page: 74 / 87

12 Converting to a rackmount model 23
E
12 Converting to a rackmount model
Perform the following steps to implement the rack conversion kit and install the server in the
rack:
For details on attaching the slide rails, refer to your rack type instructions.
Placing the server in the rack
1
Open the rack cabinet.
Open the front and rear doors of the rack.
2
Place the server in the rack.
You can position the server at various
heights in the rack by aligning the base of
the server to match to any narrow space
(between the rack holes).
Installing the rails
(For "standard-type" rack only)
1
Attach the spring-nuts provided in this kit to the rack.
Insert the spring-nuts into the rack grooves as shown in steps 1-4. The spring-nut posi-
tions can be adjusted by sliding each nut up or down in the rack groove (Step 5).
[Rack support]
Narrow
space
Server baseline
2
3
45˚
4
5
1
5