Fujitsu PRIMERGY H200, Manual

Page: 91 / 155

U41147-J-Z156-2-76
81
System components and expansions Boards in PCI slots
8.4 Boards in PCI slots
8.4.1 Installing a board
Ê Shut down the operating system.
Ê Switch the server off, and pull the power plug out of the power outlet.
V
CAUTION!
The power switch does not disconnect the device from the line
voltage. To disconnect the line voltage completely, remove the power
plug from the grounded power outlet.
Ê
Open the server (floorstand model only), and remove the top cover, the side
cover, and the slot cover (see chapter “Opening and closing the server” on
page 47).
Figure 36: Removing rear slot cover plate
Ê
Press the mounting clip in the direction of the arrow (1), and remove it (2).
Ê Remove the rear slot cover plate from the slot (3).
V
CAUTION!
Do no dispose of the rear slot cover plate. To ensure that the server
components are cooled properly, you must refit the rear slot cover plate
if you remove the board.
3
2
1