32
Operating Manual
CX420
S1
Important information
4.5
Notes on installing the Dual Node Cluster
Server in the rack
V
CAUTION!
●
For safety reasons, at least two people are required to install the
Dual Node Cluster Server in the rack because of its weight and
size.
(For the Japanese market, please refer to
"
安全上のご注意
".)
●
Never lift the Dual Node Cluster Server into the rack using the
handles.
●
When connecting and disconnecting cables, observe the relevant
instructions in the "Important Information" chapter of the operating
manual for the corresponding rack. The operating manual is supplied
with the corresponding rack.
●
When installing the rack, make sure that the anti-tilt mechanism is
correctly fitted.
●
For safety reasons, no more than one unit may be removed from the
rack at any one time during installation and maintenance work.
●
If several units are simultaneously removed from the rack, there is a
risk that the rack could tip over.
●
The rack must be connected to the power supply by an authorized
specialist (electrician).
●
If the Dual Node Cluster Server is integrated into an installation that
draws power from an industrial power supply network with an IEC309
type connector, the PSU's fuse protection must comply with the
requirements for non-industrial power supply networks for the type A
connector.