CX400 M4
Upgrade and Maintenance Manual
39
Basic hardware procedures
4.1.2.2
Global Error indicator
Ê
Check the Global Error indicator on the front or connector panel of the server
(see section
"Controls and indicators" on page 183
Ê
For further diagnostics, proceed as follows:
– Hardware errors:
Check the System Event Log (SEL) as described in the "Upgrade and
Maintenance Manual" of the related server node.
– Software/agent related errors:
Check the ServerView System Monitor, available on Windows or Linux
based servers with ServerView agents installed.
I
For further information, please refer to the "ServerView System
Monitor" user guide.
4.1.3
Locating the defective component
After determining the error class by the CSS or Global Error indicators (see
section
"Determining the error class" on page 38
) local diagnostic indicators on
the system board, HDD modules and PSUs (only slide-in units) allow you to
identify the defective component.
I
For further information, refer to the "ServerView Suite Local Service
Concept (LSC)" manual.
4.1.3.1
Local diagnostic indicators on the front
Ê
Check the CSS indicator on the front panel of the server enclosure or rear
connector panel on the server.
I
In addition to local diagnostic indicators, CSS or Global Error LEDs
indicate, if the defective component is a customer or field replaceable
unit (see section
"Determining the error class" on page 38
).
