Fujitsu PRIMERGY CX122 S1, Service Supplement Manual

Page: 23 / 94

PRIMERGY CX122 S1
Service Supplement 21
Preparations
Ê Carefully slide the server out of the rack (2).
V
CAUTION!
Please keep in mind, that PRIMERGY CX122 S1 servers will tip over
or fall out of the rack if slid out too far!
Ê Remove the defective server.
V
CAUTION!
When removing a PRIMERGY CX122 S1 server from the system unit
that is not replaced immediately, always install a dummy cover in the
empty installation bay. For further information please refer to
section
"Installing a server dummy cover" on page 28 .
4.1.2 Installing a PRIMERGY CX122 S1 server in the
system unit
4.1.2.1 Rack installation
No additional mechanical parts such as support brackets or screws are required
for the installation of a PRIMERGY CX122 S1 server in the CX1000 S1 system
unit.
Figure 5: Mounting a server in the rack (A)