System expansions for rack server
Accessible drives
72
A26361-K632-Z100-1-7619
Accessible drives
The server accommodates four accessible drives (three 5 ¼-inch drives and one 3 ½-inch drive). A
5 ¼-inch drive with a full installation height occupies two 5 ¼-inch half-height bays.
For error-free operation of SCSI hard drives it is important that each drive on the SCSI bus is
assigned a unique SCSI-ID (0 - 6) and that the matching resistor (terminator) is only connected and
enabled on the drive at the end of the SCSI cable.
As the CD-ROM drive fitted by default is connected at the end of the SCSI cable, the termination is
enabled.
Ê
Read the documentation supplied with the drive and make the required settings (SCSI ID,
termination) at the drive.
Installing an accessible 5 ¼-inch drive
Ê
Open the server (see "
").
Ê
Pull the cables from the installed accessible drives.
1
2
Ê
Remove the four screws (1) and pull out the drive cage (2).
