Fujitsu PRIMEQUEST 400 Series, Installation Manual, Page: 54 / 446

2-8 C122-E001-10EN
CHAPTER 2 Setup
z
The MMB transmits packets in communication of the following types:
NTP, alarm e-mail, REMCS, and SNMP trap.
Under the following conditions, firewall, mail, and other servers must be
configured such that the packets with the physical IP address of MMB can
pass through:
- The destination server is an external server outside the firewall.
- IP addresses are restricted by the mail server used.
Also, if the REMOTE MAINTENANCE port is used with the PRIMEQUEST 520A
under the above conditions, the servers must be configured such that the packets with
the IP addresses for REMOTE MAINTENANCE can pass through.
Remarks:
z
The IP addresses of the MMB are also used for linkage with
PRIMECLUSTER.
z
If REMCS connection is involved, the connection method explained
below is used. For details, see Chapter 6, "REMCS" in the
PRIMEQUEST 580A/540A/520A/500/400 Series Reference Manual:
Basic Operation/GUI/Commands (C122-E003EN).
- Internet connection:
The REMCS ports are connected to an external switching hub or to the
center via the firewall from the external switch of the management
port.
- P-P connection:
The REMCS port of MMB is directly connected to the dial-up router.
2.2.2 MMB login and logout, and window configuration
You use the MMB Web-UI window for operations in Section 2.2.3, "Network settings
for actual operation," 2.2.4, "MMB initialization" , and 2.5, "Partition Initialization."
This section explains how to log in to MMB Web-UI and how to read its display.
z
Login to and logout from the MMB Web-UI (
→
2.2.2.1 )
z
Web-UI window elements (
→
2.2.2.2 )