Fujitsu PRIMEQUEST 400 Series, Installation Manual, Page: 219 / 446

C122-E001-10EN 4-33
4.3 PSA Installation (Linux: Red Hat) (PRIMEQUEST 520A/520/420)
4.3.7 Other settings
Remarks:Make this setting only if required.
z
Setting required when a replicated disk is used
You can build a new partition by using a disk copied from a partition in the same
cabinet, such as disk copy. In this case, you need to manually change the EngineID
of SNMPv3 used for the PSA internal communication.
You can change the EngineID with root authority as follows:
1
Use the ps command to check whether PSA is active.
Command syntax:
Example: PSA is active if the following processes under /opt/FJSVpsa/bin/ are
displayed.
2
If PSA is active, use the service command to stop PSA.
Command syntax:
ps ax | grep psa
# ps ax | grep psa
4562 ? S 0:00 /opt/FJSVpsa/bin/pm -o 70 /etc/opt/FJSVpsa/
global/pmpsa.conf
4563 ? S 0:18 /opt/FJSVpsa/bin/loggetd -p /
4564 ? S 0:06 /opt/FJSVpsa/bin/sisp -p /
4565 ? S 0:00 /opt/FJSVpsa/bin/mmbm -p /
4566 ? S 0:01 /opt/FJSVpsa/bin/mmbs -p /
4567 ? S 0:02 /opt/FJSVpsa/bin/fs -p /
4568 ? S 0:00 /opt/FJSVpsa/bin/ciipmi -p /
4569 ? S 7:40 /opt/FJSVpsa/bin/cilog -p /
4570 ? S 8:47 /opt/FJSVpsa/bin/cios -p /
.
.
4578 ? S 0:00 /opt/FJSVpsa/bin/cisalchild 1 /
4819 ? Sl 0:00 /opt/FJSVpsa/bin/webgate -p /
21670 pts/5 S+ 0:00 grep psa
/sbin/service y30FJSVpsa stop