Fujitsu PRIMEQUEST 400 Series, Installation Manual, Page: 198 / 446

4-12 C122-E001-10EN
CHAPTER 4 Work Required After Operating System Installation
Note: If a network has already been configured for the management LAN, use the
IP address specified in the ifcfg file as the IP address for PRIMECLUSTER
GLS and configure the duplication settings by following the instructions in
the PRIMECLUSTER GLS manuals.
After configuring the duplication settings by the GLS, restart the network
service and then restart the PSA.
Command syntax:
4.2.2 Checking the SELinux function settings
On the OS (redhat Linux) running in the partition on which you are installing the
PSA, check whether SELinux functions are enabled. If they are, disable them.
The PRIMEQUEST system runs with the SELinux functions disabled.
Do as follows to verify whether the SELinux function is disabled. If not, disable it by
editing the config file (/etc/selinux/config).
z
Checking the setting
z
Changing the setting
/sbin/service y30FJSVpsa stop
/sbin/service y30FJSVpsa start
#cd /etc/selinux/
#more config
.........
SELINUX=disabled
.........
# vi /etc/selinux/config
Change the following definition:
.........
SELINUX=disabled