Fujitsu PRIMEQUEST 1000 Series, Installation Manual

Page: 108 / 344

For direct transfer of a PSA expansion trap from a partition, set the SNMP trap destination and PSA trap
notification. For details, see 6.3.3 Setting the destinations of traps from a partition .
Remarks
You can confirm a trap destination setting by using the standard trap of the SNMP service. (See How to
confirm a trap destination setting in 6.3.3 Setting the destinations of traps from a partition .)
7. Set the destinations of SNMP traps and e-mail via the MMB.
Make settings only as needed, such as for linkage with operations management software.
1. Display the [SNMP Configuration] menu in the MMB window, and enable SNMP.
2. Set the destinations of SNMP traps via the MMB.
(See 7.5.2 Configuring SNMP .)
8. Configure the firewall.
For Windows Server 2003: See 6.3.5 Configuring the Windows Firewall .
For Windows Server 2008: See 6.4.6 Configuring the Windows Firewall .
For Windows Server 2012: See the ServerView Mission Critical Option User Manual .
9. Set the Watchdog Timer for monitoring after a STOP error. For details, see 6.3.6 Setting the Watchdog Timer
for monitoring after a STOP error (fatal system error) .
1. Edit the PSA configuration file [pnwatchdog.conf].
2. Set the following key values:
Section: [WATCHDOG]
Key: [TIMER]
Setting value (unit: seconds): 0 (Watchdog Timer disabled), 1 to 6000 (Watchdog Timer monitoring
time)
10. Set the management LAN IP address.
Make this setting only if you need to change the management LAN IP address. For details, see 6.3.7 Setting
the management LAN IP address .
11. Install updates of PSA and other bundled software.
Check the latest versions of the software at their download sites, and install the necessary updates. For details
on PSA, see 6.3.8 Installing a PSA update .
12. Configure the dump area.
Confirm that the hard disk has enough free space before collecting a memory dump. For details, see 11.4.4
Setting up the dump environment (Windows) in the PRIMEQUEST 1000 Series Administration
Manual (C122-E108EN).
13. Configure the NTP client.
Configure the NTP server on the operating system side. For details, see 7.2 Configuring NTP .
14. Save management and configuration information. For details, see 6.8 Saving Management and Configuration
Information .
PRIMEQUEST 1000 Series Installation Manual
CHAPTER 4 Installing the Operating System and Bundled Software
80 C122-E107-09EN