Fujitsu Oracle M10-1, Service Manual

Page: 93 / 254

XSCF> showdate
Mon Jan 1 09:17:24 JST 2001
XSCF>
setdate -s 102016592013.00
XSCF>
version -c xcp -v
BB#00-XSCF#0 (Master)
XCP0 (Current): 2011
CMU : 02.01.0001
(*1)
6.3.1 Setting the time
1. Check that the XSCF STANDBY LED on the operation panel is on.
2.
Log in to the XSCF shell.
3. Execute the showdate command to display the XSCF time.
In the following example, the current local time is displayed.
4. Execute the setdate command to set the XSCF time.
Specify the time in either of the following formats:
yyyy.MM.DD-hh:mm:ss year.month.day-hour (24-hour clock):minute:second
MMDDhhmmyyyy.ss monthdayhour (24-hour clock) minuteyear.second
In the following example, "October 20, 2013 16:59:00" is specified.
6.3.2 Confirming the firmware version
1. Log in to the XSCF shell.
2. Execute the version command to confirm the firmware version information.
If the XCP firmware version does not match that used before the replacement,
update the firmware.
For details, see "16.5 Updating Firmware" in the Fujitsu SPARC M12 and Fujitsu
M10/SPARC M10 System Operation and Administration Guide .
If you replace the microSD card, the CMU firmware versions do not match.
However, you do not need to perform an update.
The following example shows "02.01.0001" (*1 in the execution example) as the
CMU firmware version of the current XCP, and "02.00.0006" (*2 in the execution
example) as the CMU firmware version of the reserve XCP. Thus, you can see
that the CMU firmware versions do not match.
Chapter 6 Understanding the Preparations for Restoring the System 79