Fujitsu Oracle M10-1, Service Manual

Page: 71 / 254

{0} ok
printenv boot-device
boot-device = /pci@8000/pci@4/pci@0/pci@0/scsi@0/disk@p0,0
Note - If the XSCF startup mode is high-speed mode, hardware cannot be replaced using the
replacefru command. Replace hardware with the input power turned off.
XSCF> replacefru
------------------------------------------------------------------------------
Maintenance/Replacement Menu
Please select a type of model which has FRU to be replaced.
1. FAN (Fan Unit)
2. PSU (Power Supply Unit)
------------------------------------------------------------------------------
Select [1,2|c:cancel] :
1
------------------------------------------------------------------------------
Maintenance/Replacement Menu
Please select a FRU to be replaced.
No. FRU Status
--- ------------------- --------------
1 /FAN#0 Normal
5.7 Releasing a FRU from the System with
the replacefru Command
This section describes the procedure for releasing a FRU requiring maintenance from
the system. The following FRUs can be maintained.
■
Power supply unit
■
Fan unit
1. Log in to the XSCF shell.
2. Execute the replacefru command to display the maintenance menu.
3. Select the FRU requiring maintenance by specifying it with a numeric key.
In the following example, since the fan unit is selected, "1" is entered.
4. Select the FRU requiring maintenance by specifying it with a numeric key.
In the following example, since FAN#6 is showing "Faulted" indicating an error,
"7" is entered.
Chapter 5 Preparations Required for Maintenance 57