Fujitsu MCJ3230SS, Product Manual

Page: 153 / 161

Fujitsu Internal Use Only
C156-E224-01EN IN-1
Index
128 MB disk 2-9
1.3 GB disk 2-9
230 MB disk 2-9
2.3 GB capacity 1-2
2.3 GB disk 2-9
540 MB/640 MB disk 2-9
A
ABORT message 4-43
active mode 4-6
actuator section 1-9
adaptability 1-4
air flow 3-3
air purity 3-4
algorithm for alternate processing 2-11
allowable input voltage and current 3-11
ARBITRATION phase 4-50
ASC and ASCQ definition 4-29
ATTENTION condition 4-54
automatic allocation of alternate data block
1-4
automatic alternate sector assignment
function 4-4
automatic spindle stop function 1-3
B
bit 2 to 0 4-44
bit 6 4-44
bit error rate after ECC processing 2-5
Block Descriptor 4-23
block descriptor 4-15
Bus Device Reset 4-4
BUS DEVICE RESET message 4-44
BUS FREE phase 4-49
C
cable connection 3-12, 3-25
cable connector specification 3-15
cache function 4-4
Caching page 4-19
cartridge case 2-9
CDB of READ (6) command 4-32
CDB of WRITE (10) command 4-33
center of gravity 3-8
changing revision number on site 6-4
check before mounting drive 3-24
check if error occurs at initial self-diagnosis
3-26
cleaning drive 5-6
cleaning kit 5-11
cleaning optical disk cartridge 5-11
cleaning procedure 5-12
cleaning procedure (1) 5-12
cleaning procedure (2) 5-13
cleaning procedure (3) 5-13
cleaning procedure (4) 5-14
cleaning tool 5-11
COMMAND COMPILE message 4-43
compatible with international standard
(media interchangeability) 1-3
configuration 1-8
confirming initial operation 3-26
conformance to SCSI-2 1-5
connecting more than one ooptical disk drive
(multi-host) 3-17
connecting more than one optical disk drive
(single host) 3-16
connecting one optical disk drive 3-16
connection check 3-27
connection mode 3-16
connector and terminal location 3-12
continuous block processing 1-5
control circuit section 1-10
control circuit section block diagram 1-10
controller circuit section 1-10
current waveform (+5 VDC) 3-11
current waveform (reference) 3-11
D
data buffer 1-5, 4-5
data security at power failure 2-6
default jumper setting 3-18
default value in Caching page 4-19
default value in flexible disk page 4-18
default value in Power condition page 4-20
default value in read-write error recovery
page 4-16
default value in Verify control page 4-21
defect descriptor 4-39
defective block slipping 1-6
defective sector management 4-4
Defect List Format of READ DEFECT
DATA (10) command 4-38
Defect List Header 4-37
defect list header of READ DEFECT DATA
(10) command 4-38
defect management 2-11