Fujitsu M3093DG, Instruction Manual

Page: 203 / 208

APPENDIX F WHITE LEVEL FOLLOWING
ALGORITHM
The white level following algorithm of line drawing mode can be selected from two types,
one is M3096E type and another is type. If the black area exits in the vicinity of
the grounding color area shown in section A.4, setting of M3096E type is recommended. If
the dark background documents and the light background documents are mixed, setting of
type may be better.
The procedure to set white level following algorithm is shown as follows. (*1)
*1 If the scanner is M3096GX, this procedure is effective from the ROM revision of
"G" or later.
a) Verify that the scanner is turned off.
b) Open the ADF cover and turn on the Power
>
switch while pulling up the top
sensor shown in Figure E.1.
c) White level following algorithm is switched between M3096E type and
type. The transition status is recognized by the LEDs.
Transition POWER READ CHECK
M3096E type Æ type Blinking Turn on Blinking
type Æ M3096E type Blinking Turn off Turn on
F $ 1