Fujitsu M3093DG, Instruction Manual

Page: 198 / 208

E.1 Change from M3093GX or M3096GX to M3096G
a) Verify the scanner power is turned off.
b) Open the ADF cover and turn on the Power
>
switch by pressing OMR sensor.
Figure E.1 Sensor location
a a a a a a a a a a a a a a a a
a a a a a a a a a a a a a a a a
a a a a a a a a a a a a a a a a
a a a a a a a a a a a a a a a a
OMR sensor
a a a a a a a a a a a a a a
a a a a a a a a a a a a a a
a a a a a a a a a a a a a a
a a a a a a a a a a a a a a
a a a a a a a a a a a a a a
a a a a a a a a a a a a a a
a a a a a a a a a a a a a a
a a a a a a a a a a a a a a
Open the
ADF cover.
a a a a a
a a a a a
a a a a a
a a a a a
ON
a a a a a a a a a a a a a
a a a a a a a a a a a a a
a a a a a a a a a a a a a
a a a a a a a a a a a a a
B5 sensor
a a a a a a a a a a a a a a a a
a a a a a a a a a a a a a a a a
a a a a a a a a a a a a a a a a
a a a a a a a a a a a a a a a a
a a a a a a a a a a a a a a a a
a a a a a a a a a a a a a a a a
a a a a a a a a a a a a a a a a
a a a a a a a a a a a a a a a a
A4 sensor
(M3096GX)
a a a a a a a a a a a a a a
a a a a a a a a a a a a a a
a a a a a a a a a a a a a a
a a a a a a a a a a a a a a
Top sensor
c) The PRODUCT IDENTIFICATION is switched from "M3093GX", "M3096GX"
to "M3096G". If PRODUCT IDENTIFICATION has already been changed to
"M3096G", it will be reset to "M3093GX", "M3096GX". The transition status is
recognized by the LEDs.
Transition POWER READ CHECK
M3093/96GX Æ M3096G Blinking Blinking Turn off
M3096G Æ M3093/96GX Blinking Turn on Turn off
d) When transition status is recognized, close the ADF cover and turn off the
Power
>
switch.
e) From the next Power
>
on, changed PRODUCT IDENTIFICATION is returned.
Only the product name is changed. Lower
>
case characters those indicate options
are not affected. The tables below show how PRODUCT IDENTIFICATION is
changed by this procedure.
E $ 2