Fujitsu Lifebook T580, Operating Manual

Page: 87 / 123

Security functions
Error messages
Errormessages
In this chapter you will fi nd the error messages which are generated by the
mainboard and the SmartCard reader.
Error Cause
Boot access denied
The SmartCard has no access rights to the system.
Check your
SmartCard
The SmartCard is either inserted incorrectly or it is not a suitable SystemLock
SmartCard.
SmartCard reader
FAILURE
An error has occurred on the serial port to the SmartCard reader. If this error
occurs frequently, the connection between the SmartCard reader and the
mainboard must be checked, or the SmartCard reader must be replaced.
While the error is present, access to the system is blocked.
Non-authorised
SmartCard
The SmartCard cannot be used on this device. The SmartCard has been
con
fi gured for a different device.
SystemLock
installation
FAILED:
An error occurred while installing
SystemLock
. Do not switch off the device,
insert the "BIOS Flash diskette" instead.
Perform a BIOS update and try the installation process again.
The SmartCard is
blocked.
Enter the PUK:
You have exceeded the maximum allowed number of incorrect PIN entries.
The SmartCard is blocked. Enter the administrator PUK to re-activate the
SmartCard. You must then enter a new User PIN to restart the system.
Trusted Platform Module - TPM (optional)
TPM Trusted PlatformModule
To use the TPM, you
must
activate the TPM in the
BIOS Setup
before the software
is installed. The condition for this is that you have assigned at least the supervisor
password (see
"Security functions", Page 65 ).
Options for using the TPM
You can use the TPM in different ways:
Microsoft® BitLocker
BitLocker Drive Encryption (BDE) is a feature of Microsoft®
Windows 7 and Ultimate Editions for encryption of the hard disk
drive. Here, BitLocker uses the TPM for the storage of the recovery
data which are used for decryption of the partition.
It is also possible to use BitLocker without TPM and only to use
the USB dongle for storing the crypto key. This option is mainly of
interest if Windows 7 is installed on a computer on which TPM is
not installed or an older version (before Version 1.2) is installed.
For BitLocker to work, you must have set up at least two partitions
on your hard drive. The
fi rst partition contains the boot information.
The second, larger partition is encrypted and contains the operating
system as well as the user data.
Important:
The partitions must be set up before Windows 7 is
installed.
Fujitsu Technology Solutions 83