Fujitsu Lifebook L440, User Manual

Page: 70 / 199

C A U T I O N
If your notebook beeps a series of
beeps that sounds like a code and the
display is blank, please refer to the
Troubleshooting Section.
(See pages
148-155.) The Troubleshooting Section
includes a list of error messages and
their meanings.
(See pages 158-160.)
S e c t i o n F o u r
60
Routinely Entering the Setup Utility
You can enter the setup utility whenever you
turn on or reset the system. To do this:
1. Allow the system to start booting.
2. As soon as the Fujitsu Logo appears on
the screen, press the F2 key.
3. The Main Menu of the setup utility appears
with the current settings displayed.
4. If you wish to go to one o f the other setup
menus, press the
Ó
or the
È
key to find the
menu you require.
P O I N T
If your data security settings require it,
you may be asked for a password before
the Main Menu will appear.
settings stored in your BIOS memory, or there
is a failure in the system,the system beeps
and/or displays an error message after the
Power On Self Test (POST). If the failure is not
too severe,it will give you the opportunity to
modify the settings of the setup utility, as
described in the following steps:
1. When you turn on or restart the computer
there is a beep and/or the following message
appears on the screen:
Error message - please run SETUP
program Press <F1> key to con-
tinue, <F2> to run SETUP
2. If an error message is displayed on the screen,
and you want to continue with the boot
process and start the operating system
anyway, press the
F1 key.
P O I N T
If your data security settings require it, you
may be asked for a password before the
operating system will be opened.
3. If an error message is displayed on the screen,
and you want to enter the setup
utility, press the
F2 key.
4. When the setup utility starts with a
fault present,the system displays the
following message:
W a r n i n g !
Error message
[ C o n t i n u e ]
5. Press any key to enter the setup utility. The
system will then display the Main Menu with
current parameter values.
Entering the Setup Utility After a
Configuration Change or System Failure
If there has been a change in the system config-
uration that does not agree with the parameter