Quick Installation Guide
Fujitsu Technology Solutions GmbH, User Documentation, 33094 Paderborn, Germany
Email - [email protected]
Online - http://ts.fujitsu.com/support
All hardware and software names used are trademarks of their respective manufacturers.
590-341-609F
installation
2
KVM series2-Adapter
The following instructions will help you
install and use your KVM series2-
Adapters easily.
Should you require further assistance, please
consult your installer/user guide.
About the KVM series2-Adapter module
The KVM series2-Adapter module is one part of the
KVM series2 system and is designed to drastically
reduce cable bulk. Choose between PS/2, USB and Sun
cable options. Use your KVM series2-Adapter module
to convert keyboard, monitor and mouse signals from a
server through a single CAT 5 cable (up to 98.5 feet or 30
meters) to your unit.
The KVM series2-Adapter module draws its power from
the server and has Keep Alive functionality that will keep
your server working properly with or without connectivity
to the KVM series2 unit.
Troubleshooting tip
Make sure your server is powered up before operating
your KVM series2 system. If a server is unavailable
through OSCAR, doublecheck your cable connections or
test another KVM series2-Adapter module in its place.
Optimal screen resolution
For an optimal screen resolution of 1280x1024, limit
the cable length between the switch and the attached
servers to 15 meters. Cable lengths greater than 15
meters will limit screen resolution.
Maximum
Cable Length
1280x1024
@ 85 Hz
1024x768
@ 85 Hz
800x600
@ 85 Hz
3 meters (9.2 feet)
Supported
Supported
Supported
15 meters (49 feet)
Supported
Supported
Supported
30 meters (98.5 feet)
Supported
1
Connecting the KVM series2-Adapter
to your unit
Choose an available port, labeled 1-16, on the rear of
your unit. Plug one end of a CAT 5 cable into a numbered
port and the other end into the RJ45 connector of a KVM
series2-Adapter module.
2
Connecting a server to the KVM
series2-Adapter
Plug the KVM series2-Adapter module’s VGA monitor,
keyboard and mouse connectors into the appropriate
port on the back of a server. Repeat this procedure for all
servers that are to be connected to the KVM series2 unit.
NOTE
: For use with Listed Information Technology
Equipment (I.T.E.).
3
Powering up your system
Power up your servers and KVM series2 unit. Ensure that
your unit is properly con
fi
gured, then begin operation of
your system.
For additional information
For further information, please refer to the KVM series2
Installer/User Guide included with the unit. For the latest
software and
fi
rmware updates, check www.fujitsu.com.
KVM series2-1602 Appliance
KVM series2-Adapter
module - Sun
KVM series2-Adapter
module - USB
The KVM series2-Adapter-PS/2
can connect either a server or
a cascade switch to your KVM
series2-1602 unit
KVM series2-Adapter
module - PS/2
CAT 5 cable -
up to 98.5 feet
(30 meters)
