Chapter 8 Operational Settings
160
■
Resetting the Sheet Counters
When you have replaced or cleaned a consumable part, reset the
corresponding counter by using the following procedure:
1
If you have replaced a consumable, click the [Clear]
button of the consumable that you replaced. If you
performed cleaning, click the [Clear] button of [After
cleaning].
The counter is reset to 0.
For the ink counter, the value will be set to 100.
2
Click the [OK] button.
A confirmation message appears.
3
Click the [OK] button.
The settings are saved.
Pick Roller
Number of sheets scanned after the pick
roller is replaced
The number of sheets is counted in
increments of 500.
Remaining Ink
Amount of ink remaining in the print
cartridge of the imprinter
(only displayed when the imprinter is
installed)
ATTENTION
If you turned off the scanner by unplugging the power cable, or
selected [Disable power switch], the number of scanned sheets
may not be counted in [Total Count].
For details about disabling the power switch, refer to
Turning the Scanner ON/OFF [Power SW Control]" (page 185)
.
Item
Description
