Chapter 7 Troubleshooting
86
The Function Number Display or the [Power]
button or both switch off.
Has the scanner been left out of operation for a long time
after being powered on?
Yes
The scanner has entered power saving mode or has been automatically turned off.
If the scanner has entered power saving mode
The Function Number Display turns off but the [Power] button light remains
green.
Resume from power saving mode by one of the following methods:
- Load a document in the ADF paper chute (feeder)
- Press any button on the operator panel
Note that pressing the [Power] button for more than 2 seconds will turn the
power off.
- Perform scanning from an application
If the scanner has been automatically turned off
The Function Number Display and the [Power] button light are off.
Turn on the scanner.
For details, refer to
"1.3 Turning the Power ON/OFF" (page 19)
No
Does the Function Number Display and the [Power] button
light remain off even if you turn the scanner off and then on
again?
No
The scanner is operating correctly.
Yes
If the problem persists, check the items in
"7.4 Before You Contact the Scanner
first, then contact your FUJITSU scanner dealer or
an authorized FUJITSU scanner service provider.
