![Fujitsu Fi-7030 Operator'S Manual Download Page 142](http://html.mh-extra.com/html/fujitsu/fi-7030/fi-7030_operators-manual_120731142.webp)
Chapter 8 Operational Settings
142
Specifying the Sensitivity Level for Vertical
Streak Detection
[Vertical Streak Sensitivity]
Specify the sensitivity level to detect vertical streaks (dirt on
the glass sections) when vertical streak detection is enabled.
Select [Low] to only detect large amounts of dirt on the glass
sections. Select [High] to also detect small amounts of dirt on
the glass sections.
1
Start up the Software Operation Panel.
For details, refer to
"8.1 Starting Up the Software Operation Panel"
.
2
From the listing on the left, select [Device Setting 2]
[Vertical Streak Sensitivity].
3
Specify the sensitivity level for vertical streaks.
Low: Decreases the sensitivity level to detect dirt on the glass
sections.
Normal: Monitors dirt on the glass sections with normal sensitivity.
Keep this setting for normal use.
High: Increases the sensitivity level to detect dirt on the glass
sections.