Chapter 8 Operational Settings
138
Waiting Time in Manual Feed Mode
[Manual-feed timeout]
When you scan by manually loading one sheet at a time, you
can specify the waiting time (interval) for loading the next
document in the ADF paper chute (feeder). This enables
continuous scanning as long as you load a document within
the set time.
If the set time is exceeded, the scan is finished automatically
and manual feeding will be canceled.
Note that you can also press the [Send to] button on the
operator panel to cancel manual feeding.
1
Start up the Software Operation Panel.
For details, refer to
"8.1 Starting Up the Software Operation Panel"
.
2
From the listing on the left, select [Device Setting 2]
[Manual-feed timeout].
3
Specify whether to enable or disable [Manual-feed
timeout].
If you selected [Enable], then also specify the time period for which
the scanner waits to confirm that no documents are loaded in the ADF
paper chute (feeder), which is the interval between the time when the
scanner scanned the last document and the time when the scanner
checks whether the next document to be scanned is loaded, in
[Paper-out detection time].
8.7 Settings Related to Waiting Time
HINT
When [Manual-feed timeout] is enabled, the scanner will wait for
the set time even if you start scanning with no document in the
ADF paper chute (feeder).
