Fujitsu ETERNUS LT40 S2, Installing, Starting Up And Maintaining

Page: 95 / 110

Chapter 5 Servicing the Tape Library
5.10 Adding a New License Key
FUJITSU Storage ETERNUS LT40 S2/LT60 S2 LTO Library Installing, Starting Up and Maintaining
Copyright 2018 FUJITSU LIMITED P3AM-5392-07ENZ0
95
7
Remove the mounting brackets and guide pulleys from your library and install them on the
replacement library.
8
Loosen the blue thumbscrews on the power supply, and pull the power supply from your
library.
9
Install the power supply in your replacement library.
10
Loosen the blue thumbscrews on the tape drive, and pull the tape drive handle while
supporting the bottom of the drive to remove from your library.
11
Install your drive in the replacement library enclosure.
12
Loosen the blue thumbscrews on the Library controller and remove the controller from the
Library.
13
Install the Library controller in your replacement Library.
14
Remove the lock on the rear panel.
15
Store the lock and label to the top cover (see Figure 7.1 ).
16
Slide the replacement Library enclosure onto the metal rails that are already in position in
the rack.
17
Tighten the mounting bracket screws to anchor the replacement Library enclosure to the
rack.
18
Plug in the power cord and host interface cable into the replacement Library enclosure.
19
Power on the Library.
20
Run the "Library Health Check".
21
Securely package the Library enclosure that was replaced, and return to repair center (see
"Chapter 7 Packaging Before Transportation" (page 104) ).
End of procedure
5.10 Adding a New License Key
The basic models of ETERNUS LT libraries are delivered with a certain number of magazines.
If you want an upgrade (additional magazines), you have to buy a license from Fujitsu. Fujitsu will send you a
TAN, and in return you will receive a valid license number for the additional magazine.
■
Serial number
In order to get a new license key, it is presupposed to know the serial number of your system. The different
methods to get the serial number you will find in the section
"5.11 How to Get the Serial No. in Storage
Systems" (page 101) .