Fujitsu ETERNUS LT40 S2, Installing, Starting Up And Maintaining

Page: 38 / 110

Chapter 3 Operating the Tape Library
3.1 Operator Control Panel (OCP)
FUJITSU Storage ETERNUS LT40 S2/LT60 S2 LTO Library Installing, Starting Up and Maintaining
Copyright 2018 FUJITSU LIMITED P3AM-5392-07ENZ0
38
3.1.4.2 Toggle Values
Toggle values are used to switch between two different states like On and Off. After navigating to the menu
item the display shows the actual state. Pressing the ENTER button will toggle to the possible new state.
Pressing ENTER a second time will take over this new state.
3.1.4.3 Numerical Values
Numerical values are needed for network addresses, PIN entries, and other configuration entries. After
navigating to the menu item to be changed, the actual value will be displayed and the cursor stays on the first
digit. The value may be incremented / decremented with the NEXT and PREVIOUS button. After pressing the
ENTER button the cursor is set to the next editable digit. It can be changed in the same way. After pressing the
ENTER button at the last digit the complete entry will be stored. Pressing the CANCEL button will cancel the
whole edit process and the old value is valid again.
3.1.5 Power ON/OFF
Part of the Operator Control Panel is the Power On/Off button. Pressing this button will initiate a controlled
Power Down of the unit (soft landing). The following operations will take place before the unit shuts down
completely:
• The display indicates with an appropriate message that the shutdown is in progress
• The library controller finishes all ongoing loader and drive activities
• The robotics is moved to its home position
• The library controller switches off the power supply's secondary side
• To abort the shutdown process the user has to press Cancel within the first 3 seconds
The shutdown process may be aborted by pressing Cancel within the first 3 seconds.