Chapter 1 Preparation
1.1 Connection Preparation
FUJITSU Storage ETERNUS DX60 S2 Disk storage system User’s Guide -Installation-
19
Copyright 2014 FUJITSU LIMITED
P3AM-5502-05ENZ0
•
Network devices and cables
Network devices, such as LAN switches, must be prepared to connect an ETERNUS DX Disk
storage system to the LAN. When the LAN for remote support is separate from the LAN for
operation management, routers and LAN cables must be prepared to connect to the other
network.
●
Connection example without a dedicated remote support port
The MNT ports are used for the network connection of the remote support. The RMT ports are
not used.
-
For the ETERNUS DX Disk storage system, one IP address for the MNT port is required.
-
An IP address is required for a PC terminal that is used for maintenance operations
performed by a maintenance engineer.
-
Network devices such as LAN switches are required for operation management.
-
Two enhanced Cat-5 twisted-pair type LAN cables are required to connect the ETERNUS
DX Disk storage system to the LAN for operation management.
Figure 1.5
Connection example without a dedicated remote support port
IP:x.x.x.a
RMT ports are not used.
LAN switch
SNMP
manager
NTP server
Mail server
LAN for operation management
ETERNUS DX Disk storage system
Controller enclosure
RMT
MNT
CM#0
RMT
MNT
CM#1
IP:x.x.x.d
This PC terminal is used for maintenance operations.
PC terminal used for maintenance
: Enhanced Cat-5 twisted-pair type LAN cables
Remote support
center
Administration
terminal
